Poland – Refuse and waste related services – Usługa sukcesywnego odbioru, transportu oraz zagospodarowania odebranych przez Wykonawcę od Zamawiającego odpadów pod kodem 19 12 12 – inne odpady (w tym zmieszane substancje i przedmioty) z mechanicznej obróbki odpadów inne niż wymienione w 19 12 11 – gabaryty.

The subject of the order is the performance, under the conditions described in the contract to be concluded between the Purchaser and the Contractor, SWZ and in the Contractor's offer, of the successive collection, transport and disposal of waste, collected by the Contractor from the Purchaser, classified under code 19 12 12 – other waste (including mixed substances and objects) from mechanical processing of waste other than those mentioned in 19 12 11, in the quantities specified below. The waste may be subjected only to the recovery processes R1 and/or R12, according to the definition of these processes in the Waste Act of 14.12.2012 (i.e. Journal of Laws 2023.1587 with later amendments)/Annex IA to Regulation (EC) No 1013/2006 of the European Parliament and of the Council of 14 June 2006 on the shipment of waste (OJ EU L 190/1 with later amendments), where “subjection to the recovery process” means the initiation and completion of this process. The waste constitutes a fraction of waste from ground sizes with energy value from the process of processing large-sized waste in the amount of 2500 Mg (+/-) 10 Mg (quantitative differences may result from storage conditions and the technical and technological solutions of the weighing system used), but not less than 350 Mg (minimum service). The waste is in unprocessed form (loose). 1. The Contractor must indicate in the tender form (Annex No. 1 to SWZ) the recovery process to which the waste will be subjected. 2. Waste Collection: a) The transfer and collection of Waste will take place exclusively on the basis of and in accordance with written [form under pain of nullity] individual orders from the Purchaser sent to the Contractor and delivered to him by electronic mail, specifying the quantity of Waste and the deadline by which the Purchaser expects their collection. b) The Purchaser will place individual orders when the quantity of Waste accumulated by him, which is to be collected on one day, will be at least 12 Mg, c) The Contractor will collect Waste while maintaining the following technical infrastructure requirements at the Purchaser's plant: • the gross weight of a single vehicle entering (empty vehicle for loading) the Purchaser's plant area must not exceed 18 tons • the distances between the extreme axles of a single vehicle must not exceed the length of 16 meters, and the length of the vehicle must not exceed 18 m • loading of loose waste transferred is done “from above” • loading of waste transferred in blocks is done with a loader “from the rear” - moving floor or side - standard trailer. 1) After weighing the vehicle loaded with Waste, the Purchaser will issue a warehouse issue document. 2) The Purchaser will prepare a Waste Transfer Note [WTN] for each batch of Waste collected from the plant operated by him by the Contractor's transport. These notes will be issued in accordance with the Waste Act. The Contractor will be responsible for the confirmation by the Operator of the Installation, in which the recovery process will be carried out, of the mass and type of Waste specified in each Waste Transfer Note issued by the Purchaser, in accordance with the Waste Act. 3) If the movement of Waste is of an international nature, the documents specified in Regulation (EC) No 1013/2006 of the European Parliament and of the Council of 14 June 2006 on the shipment of waste (OJ EU L 190/1 with later amendments) will be prepared. The documents will be prepared in accordance with the requirements of the aforementioned Regulation.